Water is the most commonly used media for cooling, be it internal
combustion engine, compressors, furnaces, Air conditioners etc. the reason
being it absorbs maximum heat per cubic centimeter and does not become
a hazard. Oil and other liquids carry much less heat and are fire hazards
too. Water, as obtained naturally, has one major problem i.e. tendency
to form scales on the pipes or other areas in which it is circulation
especially when hot.

This scale formation results in:

1. Chocking of passage resulting in less flow and consequently consumption
of more energy

2. Non-Conducting layer being formed between heat source and water,
which is taking away that heat, thus reducing efficiency of cooling.
This can be eliminated by using water softening plants which are cumbersome,
difficult to operate, incur recurring costs and can not be utilized
in all cases due to paucity of space. However all these problems can
be solved! Thanks to the revolutionary technology of treating water
which is no available!!

Magnetic Anti Scale Unit

It Works By

It is based on a process which treats water without altering its mineral
composition. Water flows through a magnetic coil from highly efficient
permanent magnets. In this cell the water crosses a magnetic field perpendicular
to the lines of induction. This contact polarizes the molecules contained
in the water, thereby disrupting the normal crystallization process
of mineral salts such as calcium and magnesium. Once these salts have
been physically modified in this way, they lose their ability to attach
themselves to the lining of pipes and tanks.

Operating Principle

Molecules (CaCo3, Potassium, Manganese, etc.) which are in natural
suspension in water, tend to form macro molecules which, if nothing
is done, continue to coagulate, causing scale to collect in the pipes
with resultant reduction in flow and increased consumption of energy.

Technical Principles

Permanent magnets are installed along the entire length of the appliance,
the lines of magnetic flux being captured by a mild iron cylinder (care
being taken that the flow-rate is not affected.)

What Is The Result?

When passing through the magnetic field, the macro-molecules are polarized
in such a way that their conglomerate structure is deliberately disorganized
so that their original molecular state of natural suspension in the
water is re-established. After passing through this induced field, they
will retain a residual magnetic charge for more than 30 hours (which
is substantially longer than the water renewal cycle, which does not
exceed 12 hours); they cannot therefore recoagulate. In the case of
ferruginous water, ferrous and ferric welding residues, an anti-corrosion
process is established (thus eliminating electrolysis phenomena.)